SunRunner Signature 25MPPT/6/PRO Core
SunRunner Signature 25MPPT/6/PRO Core
This kit is built around an MPPT charge controller and offers a digital display, system programming, battery monitoring, temperature compensation, disconnects and cable management hardware. It can regulate up to 340W of solar panels and is compatible with our roof mounted combiner boxes. Thick 6 gauge wire reduces lines losses for optimum efficiency.
What you get:
1x Blue Sky SB2512iX-HV MPPT Charge Controller
1x Blue Sky Temperature Sensor
1x Blue Sky IPN Pro Remote
1x Blue Sky Shunt Kit
30' Duplex-6/2 cable
1x Interior Wire Harness Accessory Kit
1x 30A DC Breaker with screws
1x 6ga. Breaker Positive Terminal Kit
1x 6ga. Negative Terminal Kit
1x Mini On/Off Switch with screws
2x 6ga. Lug-3/8" Ring
2" Heat Shrink tubing 1/2" red
1x Wall Box for 2512iX-HV
This is the medium power end of our Blue Sky based System Core offerings. The inclusion of the IPN Pro Remote and the shunt kit give you a full feature Battery Monitor. This monitor provides plenty of useful information about the performance of the system and your relative consumption.
To complete a system based on this Core, study this System Overview. You will see that you need to add a Combiner Box and Solar Panel Kits. You may also choose to add Tilt Bars for increased output in Winter and a tube or two of Dicor sealant to seal the roof where the mounting feet and roof combiner box are placed.
The optional add-ons list below makes it easy to build a complete system.
Installation Diagram:
SunRunner Signature 25MPPT/6/Pro
You may also be interested in:
Choose a combiner box:
This C-box is for efficiently combining solar panel output cables and sealing off a roof penetration. Its rugged and spacious design make installation and troubleshooting very easy. Do not use VHB tape on rubber (EPDM or TPO) roof material, all other roof types should use the taped option.
Dimensions: H 1.9" x W 11.61" x D 5.87"
Choose panel kits:
Choose appropriate tilt bar sets:
For tilting panels approximately 19-25” wide at roughly a 45-degree angle to increase output in the winter months. Made from corrosion-resistant stainless steel. Not recommended for the 90W Long panel.
This item includes 2pc T-Knobs for install. For Extra T-Knobs please see our listing here.
For tilting the ZS170 solar panel at a 45 degree angle for increased output in the winter months. Made from corrosion resistant stainless steel.
This item includes 2pc T-Knobs for install. For Extra T-Knobs please see our listing here.
Add sealant:
(allow 1/3 tube per panel or Roof C-Box)
AM Solar Part Number: 30s-SIG-MPP-25A or 30i-SIG-MPP-25A