Typically used between the battery bank and a 2000W or larger inverter

Sold by the foot

When using 4 or more subsystems, there are quite a few negative connections that need to be added to the shunt. By adding the Junction Post Kit Negative w/Cable, you can connect all the negatives a little easier.

This does not come assembled.

Typically used between batteries or between a battery bank and a 2000W inverter.

Sold by the foot

This kit does not come assembled.

For helpful advice on the differences between Parallel & Series connection and which might be best for you and your project, please see our wiki article here.

Cable, Lugs, and Heat Shrink needed to connect two batteries in parallel or series, depending on kit choice. These kits are ideal for 12V batteries.

Typically used between a combiner box and a charge controller in 70A (or 900W) or larger systems.

Sold by the foot

Typically used between a combiner box and a charge controller in 40A-60A (or 600W-800W) systems

Sold by the foot

Typically used between a combiner box and a charge controller in 25A-35A (or 300W-500W) systems

Sold by the foot

Typically used between a combiner box and a charge controller in 30A (or 400W) or smaller systems

Sold by the foot

Typically used between series connected solar panels and a charge controller.

Typically used between sub-panels and small AC loads.

Sold by the foot

Custom designed for AM Solar with a UV resistant jacket and a round profile that creates a tight seal through a liquid tight strain relief, this cable goes from solar panels to the combiner box.

Sold by the foot

Used to make MC-4 extension cable from solar panels to a combiner box or charge controller.  Sunlight & moisture resistant, flexible (19 copper strands), .265” diameter.

Sold as black wire by the foot.

VE.Direct cables come in a variety of lengths and are used to connect various Victron devices to monitors or remotes.

RJ45 cables come in a variety of lengths and are used to connect various Victron devices to monitors or remotes.

Every Victron lithium battery has a male and a female M8 cable.  These cables connect batteries together in a series chain with the ends going to the VE.Bus BMS.  If components aren’t close enough for the standard battery cables these extensions can be used to get more length.  Each cable has a male and a female end.

Typically used as signal wire between a shunt and monitor.

Sold by the foot

Typically used between the SPS and the main panel in systems designed for a 50A service

Sold by the foot

Typically used between main or sub-panels and an inverter, or between the inverter and the SPS in systems designed for a 50A service

Sold by the foot

Typically used between main or sub panels and an inverter in systems designed for 30A service

Sold by the foot

Protect cables from abrasion by covering them in split loom.

Sold by the foot

Allows for programming of an inverter using a PC.

The VE.Direct to USB interface connects products with a VE.Direct connection to devices with a USB port, for example a computer. With this cable it is also possible to connect more than two VE.Direct products to a single CCGX.

This cable is used to interface a Victron SmartSolar MPPT charge controller with a Victron lithium system BMS. It is not recommended for charge controllers with a CD port or systems where a Color Control GX, Venus GX, or Cerbo GX monitor will be used.

This interface is used in Hub-1 systems with grid-feedback enabled. It interfaces between the VE.Bus system and one or more MPPT solar chargers with a VE.Can connection: the MPPT 150/70 and/or MPPT 150/85.