Clean, fray free wire ends assure the best connections. Good connections carry electricity with very little loss of “power”. And good, solid wire connections begin with a SHARP WIRE CUTTER.

Every electrical connection in an RV should be protected from corrosion by sealing the exposed wires. Heat Shrink does this. True, there are those who pull out a BIC to heat up shrink tubing, but unless you are way more experienced than lucky, then you need a TWO SPEED HEAT GUN.

Lost in the woods? Get out your Map and Compass to find where you are and where you need to go. So it is in Electrical Circuits, you need direction. From Design to Lay Out and Testing the only guide you’ll need is this solid, digitally accurate, fuse protected DIGITAL MULTIMETER.

Solid “Electro-Mechanical” connections are the only way to assure a continuous flow of electricity. The best way to make a solid crimp on BIG wire is with the HAMMER CRIMPER.

Crimp lugs and butt splices onto cables.

Measure AC loads to determine power consumption and size your system

Use this driver tip with the security bolt T-knob alternative fasteners.