SunRunner Signature 40MPPT/4/Pro Core
SunRunner Signature 40MPPT/4/Pro Core
This kit is built around an MPPT charge controller and offers a digital display, system programming, battery monitoring, temperature compensation, disconnects and cable management hardware. It can regulate up to 540W of solar panels and is compatible with our roof mounted combiner boxes. Thick 4 gauge wire reduces lines losses for optimum efficiency.
What you get:
1x CCTLR-BS-MPP-040A Blue Sky SB3024iL MPPT
1x TEMP-BS Blue Sky Temperature Sensor
1x 97-3024SCRWS Screws for SB3024iL
1x 97-3024HDK 3024iL Hardware Kit
1x MONITOR-IPNP IPN Pro Remote
1x 96-IPNRSK IPN Pro Remote Shunt Kit
30' CABLE-4GA-2-GRY Duplex-4/2
1x 92C-INTR Interior Wire Harness Acc. Kit
1x 93B-050A 50 Amp DC Brkr. w/Screws
1x 93T-POS-4GA 4ga Brkr Pos Term Kit
1x 93T-NEG-4GA 4ga Negative Terminal Kit
1x 93S-MINI Switch-Mini On/Off w/Screws
2x LUG-4GA-RING-3/8 4 ga. Lug-3/8" Ring
3" HS-RED-HD-1/2 Heat Shrink 1/2" Red
This is the high power end of our Blue Sky based System Core offerings. The inclusion of the IPN Pro Remote and the shunt kit give you a full feature Battery Monitor. This monitor provides plenty of useful information about the performance of the system and your relative consumption.
To complete a system based on this Core, study this System Overview. You will see that you need to add a Combiner Box and Solar Panel Kits. You may also choose to add Tilt Bars for increased output in Winter and a tube or two of Dicor sealant to seal the roof where the mounting feet and roof combiner box are placed.
The optional add-ons list below makes it easy to build a complete system.
Installation Diagram:
SunRunner Signature 40MPPT/4/Pro
You may also be interested in:
Choose a combiner box:
Be advised: The Refrigerator Vent C-box can be modified to work with the 4 gauge cable in this system core but it is difficult to work with and usually discouraged.
Choose panel kits:
Choose appropriate tilt bar sets:
For tilting panels approximately 19-25” wide at roughly a 45-degree angle to increase output in the winter months. Made from corrosion-resistant stainless steel. Not recommended for the 90W Long panel.
This item includes 2pc T-Knobs for install. For Extra T-Knobs please see our listing here.
For tilting the ZS170 solar panel at a 45 degree angle for increased output in the winter months. Made from corrosion resistant stainless steel.
This item includes 2pc T-Knobs for install. For Extra T-Knobs please see our listing here.
Add sealant:
(allow 1/3 tube per panel or Roof C-Box)
AM Solar Part Number: 30s-SIG-MPP-40A