35mm Rocker Foot Mount Set for Zamp Panels
35mm Rocker Foot Mount Set for Zamp Panels
For use with the 35mm (1.38") frame of Zamp Legacy solar panels. Made of corrosion resistant stainless steel.
AM Solar Rocker Foot Mount Sets are the culmination of decades of RV solar installation experience. The mounts are designed to attach to the short sides of the solar panels, near the corners to allow for manual tilting. No penetration is needed when installed on fiberglass or metal roofs thanks to the VHB tape. When installing on rubber, TPO or any rough surface, the included mounting screws are recommended. AM Solar was founded in 2002 and has performed thousands of RV solar installations without having a single panel detach from a roof.
This mount set includes hardware designed specifically to work with Zamp Solar panel frames.
Mounting Instructions:
1. Clean the surface you are mounting on with 91% isopropyl alcohol.
2. Set the panel with mounts on the roof and position it while the mounts are semi-loose. This will let everything settle into a natural tension-free position.
3. Go around and tighten each Bolt gradually, being careful to keep the L-Foot in the same position.
4. Lift the panel and peel the tape cover off of each mount foot.
5. Place the sticky panel back on the roof in the same exact position.
6. Check that each foot is flat against the roof, loosen knobs to make adjustments if necessary.
7. Apply the sealant by completely burying the mount foot.
8. If you have T-Knobs, it is best to check that they are tight before going on a trip.
What you get:
4x MOUNTA-35 Mount Adapter-35mm
4x MOUNTL-3 L Foot-3 Hole
1x 91M-ZMPBLTKIT Zamp Mounting fastener kit
8x FSTBLT-1412SS Bolt-Hex 1/4-20x1/2 SS
4x FSWASH-SPL-1/4 Washer-Split 1/4" SS
8x FSTSCW-1034SS Screw-#10x3/4" PHP SMS SS
10" TAPE-VHB 3M VHB Tape-4950
Mount Dimensions:
Extension Beyond Panel Edge (per side)
Rocker Mounts
91M-35MA
1-1/4”
”Z” Bigfoot Mount Set
91M-35MA
0”, 1-1/8”
Elevation Above Surface
Rocker Mounts
L Foot - 3 Hole (Standard)
MOUNTL-3
1-1/8”, 1-1/2”, 1-7/8”
L Foot - 5 Hole
MOUNTL-5
1-1/8”, 1-1/2”, 1-7/8”, 2-1/4”, 2-5/8”
L Foot - Tall 3 Hole
MOUNTL-T3
3”, 3-3/8”, 3-3/4”
”Z” Bigfoot Mount Set
91M-35MA
1-1/2”
You may also be interested in:
Dicor protects the VHB tape from the elements. Use it to seal around mount feet, cable management hardware and combiner boxes attached to roofs.
Ideal for Airstream roofs, Teroson protects the VHB tape from the elements and is UV rated. Use it to seal around mount feet, cable management hardware, and combiner boxes attached to roofs. Do not use Teroson on TPO roofs.
AM Solar Part Number: 91M-35MZ, 91M-35MZ2t, 91M-35MZ4t, 91M-35MZ5h