MultiPlus 12/2000/80-50 - 120V Inverter/Charger
MultiPlus 12/2000/80-50 - 120V Inverter/Charger
The MultiPlus is a powerful true sine wave inverter, a sophisticated battery charger that features adaptive charge technology and a high-speed AC transfer switch in a single enclosure. Rated at 2000VA.
Note: Some Keurig coffee makers are known to be incompatible with inverters. In some cases, this will just result in a loud buzzing noise while operating, and in other cases, it will result in inverter overload and failure to operate. This doesn't mean your inverter will be damaged or that trying to use your coffee maker is dangerous; however, AM Solar cannot support compatibility issues resulting from a Keurig coffee maker. We recommend doing some research and purchasing a different coffee maker if you find yours to be incompatible with your inverter system.
Please note there is currently a nation-wide shortage of Duplex AC breakers (primarily 15/20). Our kits are designed to include these, but we may need to make substitutions due to stock level. Please email info@amsolar.com if you have any questions about this.
Steady State: 1600W
Surge: 4000W
Voltage Output: 120V AC
Voltage Input: 9.5-17V
No Load Draw: 3-9W
Waveform: Pure Sine
Frequency: 60hzCharger: 80A
Passthrough: 50A
Efficiency: 92%
Dimensions: H 19.70" x W 9.21" x D 5.75"
Extra: PowerAssist
Kit types:
Inverter Only (needs kit) (INV-VT-2000)- This is just the MultiPlus. It does not include the Digital Multi Control, MK3-USB Interface for programming, cables, disconnects, lugs, heat shrink or any of the components needed to incorporate it into a functioning system. You would only buy this if you already had all the other components.
RV Upgrade Kit Full Pass (99-VT2000KITFP) - This is a kit that includes all the components commonly needed to install the MultiPlus into an RV that already has a main panel and shore power connection.
RV Upgrade Kit (99-VT2000KIT) - This is a kit that includes all the components commonly needed to install a programmed MultiPlus into an RV that already has a main panel and shore power connection.
Empty Shell Kit (98-AC2000) - This is like the RV Upgrade Kit, but it is designed for vehicles like van conversions or skoolies that do not have any existing wiring. This kit includes the main panel and a shore power connection.
RV Upgrade Kit - What you get:
1x INV-VT-2000 PMP122200100 MultiPlus 12/2000/80-50 - 120V Inverter/Charger combi.
1x MONITOR-VTDM DMC000200000R Digital M. Contr.200/200A GX
1x CABLE-VT-RJ45-5 ASS030065000 RJ45 UTP Cable 5m
8x LUG-4/0-RING-3/8 4/0 Lug-3/8" Ring
12' CABLE-4/0-1-BLK Cable 4/0
1x STRN-S-11/4 Strain Relief 1-1/4"
6x 93H-R3/4 Heat Shrink Red 1.5" x 3/4"
2x 93H-B3/4 Heat Shrink Black 1.5" x 3/4"
1x 95F-CLST-300A 300A Class T Fuse & Holder
1x 93S-MINI Switch-Mini On/OFF with Screws
16' CABLE-10GA-3-GRY Stranded 10/3
1x BOX-SPBS Sub Panel Brkr. Box-Surface
Breakers include 1x 30A input and 4x load breakers
RV Upgrade Kit Full Pass - What you get:
1x INV-VT-2000 PMP122200100 MultiPlus 12/2000/80-50 - 120V Inverter/Charger combi.
1x MONITOR-VTDM DMC000200000R Digital M. Contr.200/200A GX
1x CABLE-VT-RJ45-5 ASS030065000 RJ45 UTP Cable 5 m
8x LUG-2/0-RING-3/8 4/0 Lug-3/8" Ring
12' CABLE-2/0-1-BLK Cable 4/0
2x STRN-S-3/4 Strain Relief 3/4"
6x 93H-R3/4 Heat Shrink Red 1.5" x 3/4"
2x 93H-B3/4 Heat Shrink Black 1.5" x 3/4"
1x 95F-CLST-300A 300A Class T Fuse & Holder
1x 93S-MINI Switch-Mini On/OFF with Screws
30' CABLE-10GA-3-GRY Stranded 10/3
1x BOX-MSB Midnite Solar Baby DIN Mnt Box
1x BRKR-AC-DIN-277V/30A 120VAC/30A DIN Mnt Breaker
Empty Shell Kit - What you get:
1x INV-VT-2000 PMP122200100 MultiPlus C 12/2000/80-50 - 120V Inverter/Charger combi.
1x MONITOR-VTDM DMC000200000R Digital M. Contr.200/200A GX
1x CABLE-VT-RJ45-5 ASS030065000 RJ45 UTP Cable 5 m
8x LUG-4/0-RING-3/8 4/0 Lug-3/8" Ring
12' CABLE-4/0-1-BLK Cable-4/0
6x 93H-R3/4 Heat Shrink Red 1.5" x 3/4"
2x 93H-B3/4 Heat Shrink Black 1.5" x 3/4"
1x 95F-CLST-300A 300A Class T Fuse & Holder
1x 93S-MINI Switch-Mini On/OFF with Screws
25' CABLE-10GA-3-GRY Stranded 10/3
2x SPLICE-12-CEC 37025 10-12 ga. Closed End Crimp
1x CORD-30A-25-L Shore Power Cord, 30A, 25' Locking
1x INLET-30A-B Power Inlet - 30A - Black
1x BOX-MSB 053-00089 Midnite Solar Baby DIN Mnt Box
1x BOX-SGSB 1328868 Sngl Gang Shallow flush (old work box)
1x BRKR-AC-DIN-277V/30A 053-03067 277VAC/30A DIN Mnt Breaker
1x BOX-SPBS TT120SLGNM Sub Panel Brkr. Box-Surface
1x STRN-S-11/4 CHE 2633 Strain Relief 1-1/4"
2x STRN-S-3/4 CHE2631 Strain Relief 3/4"
20' CABLE-14GA-2-WHT Romex-14-2
1x OUTLET-15125 1236278 15A/125V Outlet
1x OUTLET-DPLX 1236430 Duplex Outlet Cover (WHT)
Breakers include 1x 30A input and 4x load breakers
Installation diagrams:
RV Upgrade Kit Full Pass (AGM or Drop-in Lithium)
RV Upgrade Kit (AGM or Drop-in Lithium)
Empty Shell Kit (AGM or Drop-in Lithium)
Empty Shell Kit (V4.3 Lithium)
Victron Connection Diagram
Programming: Check out the Victron MK3-USB
Multi-functional
The MultiPlus is a powerful true sine wave inverter, a sophisticated battery charger that features adaptive charge technology and a high-speed AC transfer switch in a single enclosure. Models range from 800VA to 5000VA per module.
Unique PowerAssist feature
The MultiPlus will prevent overload of a limited AC source. First, battery charging will automatically be reduced when otherwise an overload would occur. The second level will boost the output of a generator or shoreside supply with power taken from the battery.
Uninterrupted AC power (UPS function)
In the event of a grid failure or shore or generator power being disconnected, the inverter within the Multiplus is automatically activated and takes over the supply to the connected loads. This happens so fast (less than 20 milliseconds) that computers and other electronic equipment will continue to operate without disruption.
Virtually unlimited power thanks to parallel operation
Up to 6 MPs can operate in parallel to achieve higher power output. Three phase or split phase operation is also possible. Please check our data sheets to see which models have paralleling, three-phase and split phase capabilities.
For instructions on updating the firmware, check out the Victron MK3-USB Interface. Victron inverters can only be programmed with a PC.
Victron Multiplus inverter/charger kits are shipped pre-programmed your specific battery chemistry.
Educational Support:
You may also be interested in:
Typically used between batteries or between a battery bank and a 2000W inverter.
Sold by the foot
Class T Fuses are used as circuit protection between battery banks and inverters or alternators.
Dimensions: H 2.4" x W 7.1" x D 2.0"
This panel is intended both for Multiplus and Quattro inverter'/chargers. It allows PowerControl and PowerAssist current limit setting for two AC sources: a generator and shore side current for example.
Dimensions: H 1.7" x W 4.7" x D 2.6"
The VE.Bus Smart dongle is two products in one:
First of all it is the Bluetooth accessory for Victron’s range of inverter/chargers: Multiplus-I, MultiPlus-II, Quattros, and range extension of Phoenix Inverters with a VE.Bus port. When installed, use the VictronConnect App to monitor operation and also operate the system: change the input current limit as well as switch between Off, On and Charger-only modes.
Secondly it can work as a Voltage- and Temperature-sense device for the inverter/charger. This works with all models.
For monitoring, the device is a great alternative in caravans, smaller yachts and motor homes for which the Color Control GX or Cerbo GX are a step too far.
Please note that the MultiPlus or Quattro must be updated to the latest firmware in order to utilize the dongle.
Dongle Dimensions: H 0.9" x W 1.7" x D 4.2"
RJ45 Cable Length: 0.9m
The Color Control GX provides intuitive control and monitoring for all products connected to it. The list of Victron products that can be connected is endless: Inverters, Multis, Quattros, MPPT 150/70, BMV-600 series, BMV-700 series, Skylla-i, Lynx Ion and even more. This kit is not a battery monitor, but it does talk to battery monitors.
Battery monitor kit with programmable relay. Measures voltage, current, capacity, and temperature. Can work with any battery type. Built-in Bluetooth. Compatible with the Color Control Monitor.
The BMV-712 is Victron's newest high precision battery monitor. The essential function of a battery monitor is to calculate ampere hours consumed and the state of charge of a battery. Compatible with all battery types. Built-in Bluetooth.
Monitor Dimensions: H 1.3" x W 2.4" x D 2.4"
Shunt Dimensions: H 1.4" x W 4.8" x D 1.6"
Cable Length: 10m
Easy start kits are typically installed on air conditioning units where the start-up surge might overwhelm an inverter. This kit also comes in a recommended Bluetooth version that allows for diagnostic feedback. Please note that the Bluetooth module does NOT allow you to control your AC unit.
Transparent Enclosure Dimensions:
7.64L x 3.58W x 2.50H in (194L x 91W x 64H mm)
Solid “Electro-Mechanical” connections are the only way to assure a continuous flow of electricity. The best way to make a solid crimp on BIG wire is with the HAMMER CRIMPER.
Clean, fray free wire ends assure the best connections. Good connections carry electricity with very little loss of “power”. And good, solid wire connections begin with a SHARP WIRE CUTTER.
Every electrical connection in an RV should be protected from corrosion by sealing the exposed wires. Heat Shrink does this. True, there are those who pull out a BIC to heat up shrink tubing, but unless you are way more experienced than lucky, then you need a TWO SPEED HEAT GUN.
Lost in the woods? Get out your Map and Compass to find where you are and where you need to go. So it is in Electrical Circuits, you need direction. From Design to Lay Out and Testing the only guide you’ll need is this solid, digitally accurate, fuse protected DIGITAL MULTIMETER.
Visit the Victron website: PMP122200100
AM Solar Part Number: INV-VT-2000, 99-VT2000KIT, 99-VT2000KITFP, 98-AC2000